Chinese Carbon MTB > 29er

Any information about ICAN S8 frame?

<< < (3/3)

Digpix:
After a long winter and very cold spring it’s finally ready!

cbenj42:

--- Quote from: Digpix on April 02, 2018, 08:33:39 AM ---After a long winter and very cold spring it’s finally ready!

--- End quote ---

Have you done any work on the linkage pivots? I found that the bearings in mine weren't installed with any loctite, just a circlip spring. There was about 1cm lateral movement in all of them.
Even after fixing that, it still seems like the manufacturing tolerances are just a little off. I've had to install some .5mm nylon spacers inside the pivots to take up the extra play.

Digpix:
I haven’t done anything to the linkage pivots. Can't feel any play in the linkage.

Navigation

[0] Message Index

[*] Previous page