Chinese Carbon MTB > 29+ & 27+
Ican P9 build
rideczech:
I have ordered some 165mm cranks so I don't need to worry about running a decent amount of sag. Really looking forward to getting the shock and finishing the build!!
R_Pierce:
Great minds think alike! I went with 165's as well
rideczech:
The 210x55 shock that this calls for is delayed for another 50days!! So for the meantime I have found a 210x60....Have check the frame for clearance and all should be well....means for now I'll have 163mm out back!
R_Pierce:
--- Quote from: rideczech on September 17, 2017, 08:40:55 AM ---The 210x55 shock that this calls for is delayed for another 50days!! So for the meantime I have found a 210x60....Have check the frame for clearance and all should be well....means for now I'll have 163mm out back!
--- End quote ---
should fit just fine! I know the P8 had plenty of room for a 200x57 when it calls for a 200x51. So I would assume you would be fine with that shock! I would run it all the time.
rideczech:
--- Quote from: R_Pierce on September 20, 2017, 05:55:35 AM ---
--- Quote from: rideczech on September 17, 2017, 08:40:55 AM ---The 210x55 shock that this calls for is delayed for another 50days!! So for the meantime I have found a 210x60....Have check the frame for clearance and all should be well....means for now I'll have 163mm out back!
--- End quote ---
should fit just fine! I know the P8 had plenty of room for a 200x57 when it calls for a 200x51. So I would assume you would be fine with that shock! I would run it all the time.
--- End quote ---
With the 60mm stroke it'll give me 163mm rear wheel travel. The cross brace contacts the seat tube at around 64/65mm stroke with an eye to eye of 210mm.... I'm also considering on finding a coil shock for it as well....but that can wait for now.... :-).... Shock arrives tomorrow.... :-)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version