Chinese Carbon MTB > 29er
Thru axle help
woodsrider:
CS-057 - There is a little slop between the thru axle and the dropouts - not much, but it is there. I'm using the thru axle that Peter sent with the frame. I've been out of the game a while and this is my first bike build with a rear thru axle. Is this normal?
Also, is there a threaded hanger that will fit this frame? I don't care for the exterior nut and the little set screw.
325racer:
Yes, there's some slop.
When the China axle no longer held I replaced it with a DT Swiss. I could not find a threaded hanger, but the DT Swiss but hold in place much better than the China one.
woodsrider:
--- Quote from: 325racer on August 06, 2018, 09:58:43 PM ---Yes, there's some slop.
When the China axle no longer held I replaced it with a DT Swiss. I could not find a threaded hanger, but the DT Swiss but hold in place much better than the China one.
--- End quote ---
Which DT Swiss axle did you get? Thanks
carbonazza:
I would firstly check if your hub is 142mm wide.
If not, maybe did forget a shim somewhere(eg: between two cassette cogs, or a hub end-cap, a shim inside the freewheel, etc. ) ?
This is a good axle a lot here are using: https://r2-bike.com/DT-SWISS-Thru-Axle-RW-RWS-12x142-mm-E-Thru
You can order a couple of nuts M12x1.5 too in case you loose one: https://r2-bike.com/SHIFT-UP-Nut-M12-for-Shimano-E-Thru-Thru-Axle-12-x-142-mm
woodsrider:
--- Quote from: carbonazza on August 07, 2018, 07:50:29 AM ---I would firstly check if your hub is 142mm wide.
If not, maybe did forget a shim somewhere(eg: between two cassette cogs, or a hub end-cap, a shim inside the freewheel, etc. ) ?
This is a good axle a lot here are using: https://r2-bike.com/DT-SWISS-Thru-Axle-RW-RWS-12x142-mm-E-Thru
You can order a couple of nuts M12x1.5 too in case you loose one: https://r2-bike.com/SHIFT-UP-Nut-M12-for-Shimano-E-Thru-Thru-Axle-12-x-142-mm
--- End quote ---
The play is within the dropouts, not between them. It's like the axle is too small a diameter, causing a little play inside the dropouts. Thanks for the link.
Navigation
[0] Message Index
[#] Next page
Go to full version