Currently down with covid so haven't been building my bike up as much as I would like. Just finished routing the cables in the integrated handlebars and frame.
Agree with Michi on the FD guide. It was a huge pain in the ass to properly cable as the OT-SP41 outer housing was not bending enough to comfortably route into the guide. The guide also wont go in if there is even a little bit of the housing peeking through. I chose to instead file a little off the top of the guide just so it goes in easier with some of the outer housing peeking out. Was sorely tempted to go eTAP out of frustration!
Rear Thru-Axle was also very difficult to remove and install once about 80% in. When the RD hanger is off the bike, it goes in easily, so no cross-threading there. Rather seems to be an alignment issue. Workaround was to loosen the hanger slightly, screw in the thru axle, and then retighten the hanger. Maybe some resin or paintwork underneath the hanger but nothing I can identify by naked eye. Any suggestions? Also, can I confirm if the provided thru-axle dimensions are as follows?
Front: 120mm M12*P1.5*L14
Rear: 173mm M12*P1.5*L15
Thanks in advance.