For those of you who have replaced the bearings in this frame, how did you get them out? My friend who has a bearing extractor tried to help me do that yesterday and we gave up after going at it hard on the lower pivot linkage. I didn't want to stress the carbon further (it's a tool that uses percussive force to pop it out) and figured I should just leave well enough alone and it's good enough for a recreational rider like me even though the bearings feel rough already after riding it for only a month.
Because of a creaking noise that wouldn't go away after re-doing the bottom bracket and seat post (One Up service) we also took apart the upper linkage that attaches to the shock. We only found bushings there whereas I was expecting to find bearings. Was I mistaken about there being bearings in there? Previous advice from this thread indicated that there would be bearings. There was one juncture of the upper linkage we didn't disassemble so maybe that's where the actual bearings mentioned are located.