Other Resources > Component Deals & Selection
Newish ZEROING crankset - Ingrid clone
kbike:
I have 2 of these cranksets. I only ridden 1 ride and other still in box. I put blue threadlocker on but I didn't like how it was wider than my other cranks so not using them. If I ever use them gunna use red thread locker or expoy. If they fail I'll tap and grub screw the basters together.
jonathanf2:
The alloy axle cranksets I've been using are Shimano compatible. Though you still need to use the same pre load crank bolt provided with the crankset. No issues yet, but I do periodically check them.
kbernstein:
I'm curious about a detail, is the crankarm bolt hollowtech2 compatible? And what does it take to install? Hex 6mm? 8mm? Some proprietary bs?
Tijoe:
First thing I thought when I saw the ZEROING cranks is: OMG, how would I ever keep all those little divots clean? They are on the front and back side of the arms. If I can't wipe then down quickly with a cloth No way would I want to have to get out a hose or the pressure washer to clean those hole out
Wet Noodle:
I'm confused as to how these are supposed to work. Is the crank bolt on the ds arm not captured below an extraction nut? From the looks of it, there isn't even a proper way to pull the ds crank arm off(?!)
Also, the bolt seems to have suffered from lowish thread engagement, but I might just be misjudging the picture.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version