See likes given/taken
Post info | No. of Likes |
---|---|
Re: FM1001 / FM1156 - 135mm frame
Leverage Ratio of the FM1001. Source: Adam February 22, 2021, 03:34:23 AM |
1 |
Re: Carbonda Gravel Carbon frame CFR707
I ran full housing for the rear derailleur past the bottom bracket and out the chainstay. For the front derailleur, I ran the housing to the stopper in that little rectangular plastic piece under the bottom bracket and then just the inner to the derailleur. I used a bit of the plastic guide that came with the frame to line the last little bit of the cable and hopefully keep dirt off. I contacted Carbonda and this is the "official" way to do it. Just for the record . I decided to run full cable housing to the front mech tough as it was stated to do this in the Shimano GRX manual. This way the cable is also protected from dirt that will come off the tire at this location. October 02, 2023, 09:44:18 AM |
1 |
Re: Carbonda Gravel Carbon frame CFR707
I replaced the fender bold at the chainstay/BB junction with a flat head bolt to make it a little easier to get the wheel on and off. I designed a screw for 3D printing that fits flush with the frame: https://www.thingiverse.com/thing:6266960 October 15, 2023, 02:25:41 PM |
2 |