I just ordered some disc brake hydraulic hose service parts. I need to cut down one of the lines on the IIIPRO E4 Mountain Bike Brakes I purchased a month ago. Until now, I have never had to cut down the hose length of a hydraulic line.
I have that muqzi needle insertion device. It works well but is probably over kill given most people do that operation using those cheap plastic blocks either side of the line and tapping the barb in with a mallet.
The cable cutter is bullshit and is hard and finicky to get a straight cut with, which is annoying as you want a straight cut to sit flush against the end of the barb. If i bought tools for this again i'd look for a proper hydro hose cutter form park or at least the Chinese equivalent.
Also have the full ezmtb bleed kit, which has been good so far.