See likes

See likes given/taken


Your posts liked by others

Pages: [1]
Post info No. of Likes
Re: Carbonda FM909 They just sent the picture of my 909 painted.
May 10, 2021, 07:08:51 AM 		8
Re: Carbonda FM909 Cable routing near the pivot. going upper of BB shell, goes to chain stay.

May 11, 2021, 03:58:11 AM 		4
Re: Carbonda FM909 Payment was PayPay. 4% is for me, cost to escalate claim in case of trouble.

Right. Specialized recent bike but they have big hole at front side. outer housing can move feely. Hope flybike follows similar design.
May 11, 2021, 10:43:23 PM 		3
Re: Carbonda FM909 Arrived. 1827g with all mouting bolts, RD hanger, cable liners, outer housing bushings. No bottle cage bolts, no shock, no protection plastics, no seatpost clamp, no headset, no BB.

all bearing rotation is far from smooth (but i dont care too much).  Shock bushing 8x30mm (8mm diameter x 30mm L to R) required (may not be included). I am contacting to seller but maybe i have to buy separately.

Any question?   
May 25, 2021, 06:27:11 AM 		7
Re: Carbonda FM909
Quote from: wfl3 on May 25, 2021, 08:17:04 AM
Is that a medium or large frame?  Thanks
My 1827g Frame is the medium. so their 17xxg claimed is maybe bear non painted frame.

just one dropper cable is routed. Internal routing is tough.
May 25, 2021, 11:07:56 PM 		4
Re: Carbonda FM909 Just done the most painful part, routings. Rear brake routing is really hard to go though. Right DS chainstay has an tunnel to go though, so RD outter housing is easy. Real pain is rear brake route.

I think you must disassemble the rear swing arm to route, but when I did so, pivot points scratch each other and making paint tips. I am not sure the best way to avoid the paint scratch since engagement is really tight. So if you cant allow any small flaw in the paint, maybe you need a special wiring tool especially for hydraulic hose. Once you pass the chain stay and get in to the front triangle, BB part and downtube part is much much easier to go.


May 28, 2021, 07:19:25 AM 		1
Re: Carbonda FM909 hahaha, sorry. my dialy job for live, makes me busy these days, and still wait for some parts. mainly bushing.
June 02, 2021, 09:31:38 AM 		1
Re: Carbonda FM909 Slower but going ahead
June 05, 2021, 09:30:47 AM 		7
Re: Carbonda FM909 I was talking to Carbonda Adam via Skype. He usually responds very soon.
Rear boost OLD is a bit too wide, measured as 150.0mm, wheel ends goes beyond its slot, a bit annoying when i put.

Ride is good. not as nimble as EPIC FS but decending fast. it is not that stiff but not feeling major flex.
June 09, 2021, 03:56:45 AM 		7