Chinese Carbon MTB Forums
News:
Happy Holidays!
See likes
See likes given/taken
| Post info | No. of Likes |
|---|---|
|
Re: ZOOM HB-910 - another trickstuff clone dh & enduro
So... I've had a good look over them and can confirm some spec and impressions: Caliper Pistons: 16mm/14mm pairs (I'd hoped they were 17/15) Lever: 10mm piston, pivots 12mm apart, with lever grip 40-75mm from the master pivot and a nice curl at the tip. Lever clamp: Compatible with Sram matchmaker clamp. (using sram clamp and bolt) Finishing: Pretty good, anodising is a little fragile and can see where it's knocked about in the box a bit on a few of the sharper edges. Initial impressions: Very good 1 lever came with one of the lever bolts half way undone, so had to tighten that up. Took the chance to strip down the lever pivot assembly and get a good look at it. No loctite on any bolts, so will add some. Can't comment on lever feel under hard pulls yet as not had it on a bar n disc yet, but initial impressions are good. There is a slight forward back play from the tolerances of the threaded pivot section on the reach adjustment pin, but this could be due to the bearings. Will look to get some 2rs bearings installed instead of the zz metal shielded ones. Pistons look to be stainless, and fully hollow under the pad. Need to reset the pistons back and check how freely they each move as they were uneven when received (had pads and spacer fitted) I think the hoses aren't done up tight enough from factory, as I could twist the lever and holding the hose it would rotate in the lever. Will take the lever off and review the barb/olive situation soon anyway as need to internally route the rear one. pics: https://www.pinkbike.com/u/scar4me/album/Stuff/ Will update again when i've had a chance to fit, bed in ad actually get some usage. December 07, 2023, 09:12:59 AM |
1 |
Re: Lexon "Riot 10"
What size bearings do i need, both at the main pivot and at the linkage? My apologies if its been answered already l must have missed it. Thanks upper shock link 6800 (19 x 10 x 5) - 2 pcs linkage 698 (19 x 8 x 6) - 4 pcs main pivot 6902 (28 x 15 x 7) - 2 pcs ENDURO MAX LLU fits fine February 16, 2024, 08:40:38 AM |
1 |