Hi all
If i refer to Yuananbike.com which is teh manufacturer for elitewheels, it look likes that the rim itself can be either used as rimbrake or Disc brake 
https://www.yuananbike.com/product/carbon-fiber-cycle-rims-38mm-depth-road-rims.

This put aside, from your posts i understand that :
- nipple angles might be different due to hub width
- hub might be difficult to find for front wheel (20 spokes)

to answer some of the questions :
Why not selling :  rim brake track can be used (not new)  and Chinese wheel don't have a great resell value
Why bothering :  i don't want to have another wheel set sitting in the garage  ,
                          for the glory of lacing a wheel by my self ?
                          for the same reason  i purchased a chiner bike and assmbled it  

based on all your comments , i'm not sure to move forward with this project, still interesting discussion.

stupid comment : it's a botch that can end with death => Only if i use brakes   

any suggestion on the ALi market  ?

Hi guys
I'm looking for a 4°flare handle bike for my road bike.
My only constraint is that it need to have round tube (no aero design).
Thanks
Nicoloc

Hi all,
Any feedback on go zone ?
I can't find build using those wheels.

Hi all some feedback on the P505 magene powermeter.
Data provided  looks weird to me with lot of variation from one second to another.
i'm comparing the data with my TACX FLux and even if average  power seems to be consistent, the variation in values make no sence.
I contacted Magene support and from their prospective (after sharing some compartive fit file)  , everything is normal...
so my point is that i cant recommend this power meter and as mention in some other post Magene support was useless.
Nicoloc

looks like i found the guilty componment :  Fonvo ring...
the ring as a design that is not compatible with the Mangene.
I had to grind off some 52 ring rear ribs that were interfeering with the powermeter ring mount (see attachements)
I'll have to check but it lookslike this shaved 2mm and the ring is now spining round.
i'll double check once reassembled on the bike.

hi guys ,
I've seen those products, but carbon version are to expensive for a fun trial
there is an alloy version, but still around the 80€ including shipping cost.
looks like there are not that much option on ali and that the kanto version is only available in philipines ...
too bad .
Nicoloc

Hi all
I pushed the trigger on the P505 from Magene.
Not recived yet...will see ...