the supports for the brake caliper are crooked, the inside part is lower than the outside and the caliper gets angle... i did not deserve this...

i put a nylon washer i had just on the inside part of the supports (not on the srew, just on the outside and between the screw and the support), to "uncrooke", or to compensate the "crookness" and it bloody works, but i cannot see a solution for this OMG!

this is the result without any compensation


in the photo attached you can see the caliper crooked and like this there is no way i can ride the bike, the rotor scraches constantly the inside of the caliper, on the top on the outside and on the bottom on the inside.

the supports on the frame for the caliper are tilted for the inside, crooked, they are higher on the ouside then on the inside, when you fasten the screw it all goes weel until you get to the end and it forces the caliper and the face of the support to touch, the caliper starts to tilt to the inside and from there all goes wrong.

Hi, dear Mr Arraider, I am so sorry to heard that bad news, both we want everything is ok, unfortunately, we come upon  this time.....actually, I should tell everybody here, our frames, every one been tested and passed the brake test.  we screwed brake on the frames!!! Surley I do not want  to pass the buck to anybody or anything, but do you mind confirm something?
1. did you use the right tools?
2. did you screw the bolts violently when it is not smoomthly, especially the firt time? because the thread will be broken when you do like that, and never been paired.
I think everyone here know this truth that the IP-256SL is a good frame,  man.  what we can do is how to slove this problem since it happened, isn't it?
So sorry for my words, surley we will try our best to serve for you guys, actually, we are doing now. thanks .
Bert

Hey thanks for the heads-up Bert!

Good info to know.

you are welcome, man.

Quote from: Sitar_Ned on June 20, 2014, 06:46:25 AM

Nice and very interesting !

To celebrate Chinertown's 1000th post, we're giving away a FREE set of 30mm carbon
29er hookless rims to one lucky forum member!

It's easy to enter the contest - but it only lasts for 20 days so enter soon!

Big thanks to Iplay for sponsoring this giveaway!

Hi, Frits?

Quote from: Bertzhong on April 16, 2014, 10:15:03 PM

it will be a great bicycle ,man. 

Thanks, Bertzhong.. Welcome to the thread and the forum!

Thanks , man, I think I can study more knowledge of the bicycle form the forum, thanks again!!

Hey guys.. Great forum idea, I could see this being a great resource in the future!

Total newb here, planning to jump in head first into my own carbon build. I was wondering if one of you guys could advise me on the differences between the IP 057 and the newer IP 256 frames?

The most of size of the 057 are in the stock now, but the 256, you have to wait many days.... about 50 days now..

it will be a great bicycle ,man.