16
29er / Re: My CS-821 build
« on: March 28, 2017, 11:58:46 PM »
More pictures.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Now we have CS-821 frame in all sizes in UD matt available in stockI will recieve mine within a few hours from you.
Never had any experience with pressfit BB only BSANothinga very thin layer of Cu grease (I almost forgot about it, I always add Cu grease to non rotating assemblies), but I've used a proper pressfit tool to get a good alignment.
No creaking so far. As I mentioned in an earlier post, I like the design of the SRAM product: the cranks provide a nice compression over the BB. It feels like the cranks keep the BB secure. Again, I would select this BB92 over a BSA now I see how nice it is.