Should be here by 4:30 PM PST per Fedex
Mine is the rim brake version with BSA threads, so remember crank side is left threaded, ie lefty-tighty  (double check this)

1. Check threads for any paints & clean the inside very carefully with a shop towel & isopropyl alcohol to get any gunk out of the threads

2. DO NOT force the threads. if doubt take it to local shop where they can get the bracket in for you or rethread if needed.

3. Ideally, you should be able to use a light smear of grease, polylube1000 or asc-1 (anti-seize) & be able to screw the bottoms in & finger tighten them without cross-threading

Thanks. Looks like the link is for eu and I was unable to find the same part here that would ship in time
Will check Amazon and I think they have the 70mm with a red top

Did you wind up cutting your steerer tube to size after doing a test fit ?

Thanks! That's really helpful. Personally, the seatpost screws being recessed doesn't really bother me that much. I'm covering it up with tape anyway. But the stem bolts just don't look right sticking out like that.

Hey anyone know what juin techs fit the 218? I want to order them but I want to get the right ones

It might have to do with the dropped stays. That creates more stress in this area. Still it shouldn’t happen of course. Let’s see how VB handle this.