Quote from: rideczech on September 17, 2017, 08:40:55 AM

The 210x55 shock that this calls for is delayed for another 50days!! So for the meantime I have found a 210x60....Have check the frame for clearance and all should be well....means for now I'll have 163mm out back!

should fit just fine!  I know the P8 had plenty of room for a 200x57 when it calls for a 200x51.  So I would assume you would be fine with that shock!  I would run it all the time.

With the 60mm stroke it'll give me 163mm rear wheel travel. The cross brace contacts the seat tube at around 64/65mm stroke with an eye to eye of 210mm.... I'm also considering on finding a coil shock for it as well....but that can wait for now.... :-).... Shock arrives tomorrow.... :-)

I have ordered some 165mm cranks so I don't need to worry about running a decent amount of sag. Really looking forward to getting the shock and finishing the build!!

Nice work..... 

How much did the decals set you back, just out of interest?

Cheers

very nice!  Whats the measured BB height from floor to center of BB?

Need to wait for the shock first for an accurate measurement...but it's low!! Around 325-330mm!!

The build has started....still waiting on the shock though... Also got some rims from Ican....they built up real nice!! I have been building wheels for 20 years and these went together the best! Great finish on the rims....

I ordered a rs super deluxe through them.  Not in stock until end of the month. They also supplied me with an x fusion sweep roughcut for cheaps! Just need to prove to customs the low value!!?
[/quote]

I ordered mine too with a super delux. Let's start another forum thread specifically for the p9. We can give reviews and update each other on build...
[/quote]

Just taken delivery...will add photos and start new thread once I'm back from shredding in the Swiss alps! :-)

New here...I will be taking delivery of an Ican P9 next week. Looking forward to seeing it in the flesh. Will post back with pics etc....