Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Builderman71

Pages: [1]
1
29er / Re: Please help me get this brake lever hose out
« on: December 01, 2017, 08:39:45 AM »
Hi-its a ZOOM HB-875 HB875 MTB hydraulic disc brake set.  I tried using a wrench to pull the hose out...no luck...it twists in the lever but doesn't pull out.  At this point I'd just cut the hose and install new but that won't help with getting the portion of hose inside the lever out.  I'll swing by the LBS today and see if they can shed any light on the issue.

2
29er / Please help me get this brake lever hose out
« on: November 30, 2017, 08:26:52 PM »
 Hi I need help removing the brake hose on a left/rear right/front zoom hydraulic brake set and I need to swap the levers so I don’t go over the handlebars. I’ve tried loosening the bleed bolt, putting the lever in a vice and pulling the hose as hard as I can  (I’m not weak)...still can’t get this hose out. And yes, I did remove the bolt joining the hose to the lever...still can’t get this @#(&&$ hose out!

Any help is appreciated.

Thanks,
Builderman71

3
29er / Re: Two cables...one hole?
« on: July 11, 2017, 05:07:36 AM »
Totally understood, but here's the thing-I know I can run both cables without housing inside the frame....what I really need is a way to have both housings 'interface' with the existing frame holes.  I still have the bike on the stand (haven't ridden yet).  I plan on looking at going to a 1x setup but for now I'm 10x3. I currently have both shimano housings going to the upper and lower holes using the rubber boots included with the housings.....does this change anything?

4
29er / Two cables...one hole?
« on: July 10, 2017, 06:57:14 PM »
Hi-I have an IP-036 (Ican) with internal cabling.  Is it possible to feasibly route the front and rear derailleur cables through the same upper and lower lower holes?  What specific cable boots or methods should I use to do this?  This is my first build so any advice is appreciated.

Thanks!

Pages: [1]