Got the frame. Well built.
Clean inner moulding. Eps or whatever it may be called.
No photos yet, dont like the small size photo uploads here.
* dont really care if you wanna say " picture or it didnt happen"
I dont have a time line for this build and there is a need to slowly get the parts, but let me tell you its real and its well built. (not too refined) but there is workarounds, so its a good frame.
First off on its issues.
1st
Shock mount sizing. Very odd sizing.
Uses 30mm on frame side and 22.2 on the linkage side.
In reality its actual spacibg is 33 or 34mm on frame side and 22.3 on linkage side. So some spacers for the shock to mount is required.
Unlike the HT v2 2020 which uses 30mm at the linkage side.
Uses metric 210x55 or 52.5
2nd
Linkage shock mount bolt is hard to get in, it seems blocked by the rear swing arm. Have not figure a way to slide it in yet with dissemble the rear swing.
3rd ( *)
Dropper housing goes from down tube to seat tube (not an issue to me)
Notes:
Low/low compreesion tune for shock. Heavier rider needs medium tunes
