Any interest in a spare nut for a Iplay 12x142 rear axle?

[outriding9800]

Im sent to ned

[blueducati]

I don't have my frame yet, but I'll take one. It sounds like I might need one. ¯\_(ツ)_/¯

[Sitar_Ned]

^^Nah.. It's nothing you need, per say.. The one you receive with your axle will work just fine - this is just a bit more of a polished solution.

I like the aesthetics. Matches the other two silver circular shapes on the derailleur below it. Anodized colors would be frkn sweet but obviously that's a bit much for the home hobby machinist. Nice craftsmanship, outriding - Tight tolerances, and fast shipping.. Thx!

[outriding9800]

Coolio..

I am glad it worked out for ya.


And yes i am a total hack when it comes to the lathe..

[MTB2223]

I'll take one. Mine never felt secure to me for some reason.. I like the idea of being able to utilize the set screw.

The nut on my 256 also never felt secure. 9 of 10 the nut is loose after a ride. Now I made it more secure by taking an old inner tube, cut a circle with diameter of 2 cm, made an incision in the middle and put the nut in. And then I put the nut on his place. Now it's secure enough and the last three rides it didn't came loose.

It's not a beautiful solution, but it works perfect for me.

[bdub]

I would be interested in buying a couple of these if you are still making them Outrider?

[outriding9800]

Yup got a handful already made..

PM your paypal account, address and how many you want and i will get you a quote.

I normally just use the post office flat rate boxes so shipping is about $5..

[Carbon_Dude]

Thought I'd bump this thread up as I was recently contacted by a forum member that has lost an axle nut and needs a replacement.

[outriding9800]

It looks like they changed the thread to a nonstandard thread.

So all new axles i dont have a nut that will work.

[byrt]

the little screw felt off and now the nut is loose!! grrrr

quick fix!

will pm andy..

[Carbon_Dude]

I think you still need the set screw even with a new axle nut.

Last week I noticed that if I tighten the set screw, then remove the axle, the nut becomes loose again.  When reinstalling the axle, I needed to re-tighten the set screw.  So if you remove the back wheel often, I can see how you will have problems with the nut coming loose more often.

[325racer]

Resurrection of an old thread......

What did you thread these as?  M12x 1.75?

Would you be able to make some in M12 x 1.5 to fit the DT Swiss axle?  I ordered the one that was supposed to have a nut, but did not get a nut, Vendor is supposedly shipping another axle, but I'll see how that arrives.

Need some solution, axle came lose during a race last week...

[JohnnyNT]

I think Shimano are M12 x 1.5 as well