Ican P9 réarmer shock

[Jucab]

Hello

My name is Julien from France
I just received my frame ican P9
I need précisions about needle bearing for the rear  shock
I measured 30 mm for the top and 25 mm for the low
CAN someone confirm because i rend in à Holmes post here 22mm

THANKS
Julien

[Icyseanfitz]

I'm using standard 22x8mm fittings for top and bottom, that's using the included shims.

[Jucab]

THANKS you for answer
Is it possible to ask you a picture of your bike Showing the rear shok ?

THANKS
Julien

[Icyseanfitz]

no bother

[Jucab]

Thank you
Another question about the seat post

did you manage to put the cable all in the frame inside for the seatpost
or must you use the issue on the left side of the seat tube ?

good day

julien

[Icyseanfitz]

I haven't installed a dropper yet, but I'm hoping to use a wireless one. However I did test routing the cable through the frame and it can go through the bottom bracket area.

[Jucab]

THANKS
I did it fully in the frame by bottons braket

[chetosmachine]

Jucab, is your dropper cable smooth? I tried when installing mine, but the result was not smooth, so i used the port on the left of the seat tube.

[Jucab]

I used the câble who was with the seatpost the race face turbine
I used the guide who was in the frame

[Jucab]

First résult

[Jucab]

And my second one for my brother
Home mode paint