Other Resources > Maintenance, Mechanics, & Tools
Best practices for disconnecting and reconnecting hydraulic brakes?
lantz:
I'm swapping internally routed integrated bars, so I need to disconnect the hydraulic hoses from the brifters and pull them out, swap bars, and reinstall.
My first thought is "There must be a way to just plug the hose while I do this so I don't have to completely drain and rebleed the brakes?"
But, I think that's naive? What steps should I take?
1. Flush the system entirely.
2. Remove olive and barb, trim hose.
3. Swap bar/brifter.
4. Install dry hoses.
5. Bleed with new fluid?
Or please god tell me there's an easier way haha.
mirphak:
6. Install non-internally routed bars to make your life easier in the future :P .
Jokes apart, I think the procedure you describe is as correct as it can get. Probably if the fluid is relatively new (and particularly if it is mineral, since it is hydrophobic) there is no need to empty the circuit completely. If reusing oil, you can more or less stop it from coming out with a round toothpick ;)
lantz:
--- Quote from: mirphak on August 14, 2024, 02:51:35 PM ---6. Install non-internally routed bars to make your life easier in the future :P .
Jokes apart, I think the procedure you describe is as correct as it can get. Probably if the fluid is relatively new (and particularly if it is mineral, since it is hydrophobic) there is no need to empty the circuit completely. If reusing oil, you can more or less stop it from coming out with a round toothpick ;)
--- End quote ---
But why would I make things easy!?
So, maybe that's the route - the brakes only have 100 miles or so on them and the fluid is pretty much brand new. I'll disconnect, plug with a toothpick and hope for the best, then just bleed after re-assembly. Good shit.
frnchy:
I always do what you described except I keep the old fluid in the syringe that I sucked it out with - that way I barely have to add any new fluid. This is assuming the old fluid is still good, and it sounds like yours is. This way the lines are empty and it’s easy and not a potential huge mess to get an internal cable routing tool into the line.
lantz:
Thanks for the tip Frnchy.
Honestly, that was easy as fuck. I used the toothpick method from Mirphak, made it so I didn't have to fuck with a full flush, re-barbed and then did a quick little bleed for any air I introduced and it was right as rain.
Navigation
[0] Message Index
[#] Next page
Go to full version