Leese carbon crankset

[hubba]

Where do you buy this?

I bought it from here https://www.aliexpress.com/item/1005012282934033.html

I'll update if it fixes the wobbling when it arrives next week.

[Ogie]

With the Leese Max, 24mm titanium cranks - anyone finding that they are coming loose mid ride?  I had it over the weekend on a bikepacking trip so only had a multitool to try and re-tighten them.

Think it is suggesting 45nm but copilot is suggesting otherwise and saying I might not have had enough spacers and therefore the bolt might be bottoming out.

[jonathanf2]

With the Leese Max, 24mm titanium cranks - anyone finding that they are coming loose mid ride?  I had it over the weekend on a bikepacking trip so only had a multitool to try and re-tighten them.

Think it is suggesting 45nm but copilot is suggesting otherwise and saying I might not have had enough spacers and therefore the bolt might be bottoming out.

I have a 24mm ti axle crankset that loosens up during rides. I'm currently using 24mm wave washers to see if it fixes the problem.

[Da11as]

Anyone can tell me how to properly tighten the 8-bolt interface spider? There is no threads on the crank... Or the spider is supposed to be hold in place by the pressure between the crank and spindle?

[hubba]

I bought it from here https://www.aliexpress.com/item/1005012282934033.html

I'll update if it fixes the wobbling when it arrives next week.

The spacer did indeed fix the wobbling issue. But the fit was not good it was bigger than the recessed area on the PP5. I had to file it smaller and it took a long time. So maybe better to order it from Thinkrider.

[kvnp]

Hi guys,

I need some advices. I got the crank arms 24mm spindle MAX version (sounds like an Apple product lol) and I am struggling to properly install them...

Even though I installed 3mm of spacers on the DS, the chainring (Ultegra R8150 and BSA BB) touches the FD. I set up the FD and I can't push the plate further inward.

If I install 4mm of spacers, I got a correct alignement but if I tight the crankset, it compresses the bottom bracket. Therefore, the crankset can't turn smoothly. On the NDS, I didn't put any spacers and the preload ring is untight.

I am kinda of stuck and running out of idea. Do you have any ideads that can help ?