Stem for vb-r-066

[cpoulsen2]

Hi,

I need a 90 mm stem for my bike. However, velo build doesn't have it on stuck until end of the month and I would really like to have it within the next few weeks since I'm joining a 300 km race.

https://www.velobuild.com/products/2023-vb-r-066-carbon-fiber-endurance-road-racing-bike-frame-disc-version

Are there any alternatives? And what about the internal cabel routing, spacers etc?

Christian

[bichler.bua]

Unfortunately I can not comment for the VB-R-066.
But I have fitted a Deda Superbox DCR system to my VB-R-099 and I believe others here have fitted FSA ACR type headsets and stems (No. 69 or No. 55) to other Velobuild frames.

[hsaus]

I have a VB-R-066. I first built it up using this upper headset assembly from Ritchey. It enables the hydraulic hoses to enter the frame via the headset dust cover, so you can use a separate handlebar and stem. Great if you want to reuse existing parts you have, or if you want to easily swap handlebar and stem for fit reasons without cutting any hoses. It comes with the upper bearing, compression ring, and dust cover only (no lower bearing or spacers): https://www.tradeinn.com/bikeinn/en/ritchey-upper-logic-e-comp-cartridge-drop-in-1.5-is52-28.6-steering-system/137710158/p

Later I swapped to this Kocevlo integrated handlebar, trading function for form: https://vi.aliexpress.com/item/1005006561735597.html

Both fit the frame. I had to sand the Kocevlo dust cover a little to prevent rubbing on the frame after tightening everything down, but that was straightforward.