Crankset for bb92

[frenzen]

Hello, I’ve a bb92 frame and need a new crank. I’m mainly looking for 165 mm ones. I was using the 160mm cruz bikes ones https://a.aliexpress.com/_mrfBFC, although it says the axle is 98 mm, I measured it at 95.8 and I used a 3 mm spacer. I stripped a bolt while using a new digital torque wrench, any recommendations is appreciated.

Has anyone used evosid cranks:

I just found this on AliExpress: C$132.84 | EVOSID 160/165/170mm Road Bike Crankset Ultralight SR 3Nails Direct Mount CNC Hollow Tech Crank 24mm Axis With Bracket
https://a.aliexpress.com/_mPthkwt

I know it says not suitable for mtb but either way throw me some suggestions for 165mm ones and 3 bolt ideally since I have a power meter.

[vermit25]

I do not have any suggestions for you, but I have had a similar issue with the same Cruz 160mm cranks on my road bike and I have recently been battling with a creak, which after months found out that the threading on one of the crank arm bolts is stripped. For now I have used some loctite on that bolt which seems to have stopped the creaking.

I am also looking for some new cranks (160mm).

[shoushou]

I had an Evosid crankset. Looked gorgeous and was light. Pain to crank to torque and be quiet. And then lasted three rides before developing play on the non drive side (which is permanently bonded to the axle). I do not have a lot of power so that was definitely not the issue.
Would not buy again.
Ordered a new set with a steel axle.