Chinertown
Other Resources => Component Deals & Selection => Topic started by: kenmc on September 01, 2025, 05:00:35 AM
-
I purchase this stem https://www.aliexpress.com/item/1005007557399904.html but the big "Kocevlo" on the sides is pretty minging.
Any suggestions on ways to go about removing this? It's not a sticker, rather something slightly more permanent but I don't know what exactly
Spray painting the whole thing is a last resort
thanks
-
I would try it with a magic eraser sponge and acetone.
-
From the pictures it could even be just laser etched (no luck then, black marker might help). Anything else and, as stated before, acetone should be your best bet.
-
Rub with acetone and soft towel
Start with a q-tip with acetone, then test how "strong" is the tampography
I always de-badge my stem/handlebar...
-
Electrical tape. Nobody will ever notice, or care. Or black vinyl if you're extra.
I'm trying to reduce weight, not add it ;D
-
Right, tried my wifes' nail varnish remover and a cottonbud/qtip no joy. can feel the printed section 'grabbing' the cotton bud as i'm rubbing, so unfortunately it seems like it might even be etched. Will try some more abrasive household cleaner stuff later in the day but might be that my only option is to spraypaint it.
-
That is a 250g stem that cost $20! And you are worried about removing the letters to save weight?
Spend $40 and get yourself a 100g stem with no lettering.
-
That is a 250g stem that cost $20! And you are worried about removing the letters to save weight?
Spend $40 and get yourself a 100g stem with no lettering.
that was a joke.
ultimately will get a lighter stem, initially looking to find the length i need.
-
Right, tried my wifes' nail varnish remover
Not to troll, but did you make sure it's acetone based? These days, many aren't
-
no, just did a test. will look closer - thanks for the tip
-
There is some very cheap aliexpress matt black sticker which I'm using sometimes for stuff like that
-
I tried acetone and other solvents.. none of them worked on my Kocevlo stem. Replaced with another "stealth" one still from Aliexpress
-
Nail polish remover ( not the acetone free version) and elbow grease.
-
If you have a little dremel with a polishing bit and some acetone usually does the trick. Potentially an electric toothbrush might work? Sometimes takes a lot of rubbing - and sometimes some extra abrasive stuff. YMMV.
-
Thanks, have a dremel, can give it a go. worst case some black paint or a sharpie will hide the worst of it until i get a nicer replacement.
-
dremel with the little polishing disc and the cutting paste didn't help at all. so used some spray paint, just sprayed it into the cap and then use an old cloth to rub it onto the stem. will take a second or third coat but seems to be most effective so far
-
couple of coats of spray paint were needed. from a meter or so away looks fine, but up close can still see the branding trying to poke through. not the end of the world, this is intended to be a temporary stem until i find the length i like