See likes

See likes given/taken


Posts you liked

Pages: [1]
Post info No. of Likes
Re: VeloBuild VB-TT-023 frame build-up
Quote from: womble73 on December 10, 2024, 04:04:47 PM
I will design and 3d print if I need to increase stack height.


You can use my file if you want to. I've used printed ones aswell without issues, to find my correct height. Once I'm done with fitting, I'll replace them though..

I only made 30mm versions, but you can strech them in your slicer obviously.

https://www.thingiverse.com/thing:6879499
December 19, 2024, 10:54:09 AM 		1
Re: Looking for a carbon triathlon frame i picked up a velobuild VB-TT-023. Still waiting on my wheels to turn up but most of the bike is put together. Only issue I have seen with the frame so far is the water bottle mount to the seat post wont fit a screw due to the hole not being round. A little bit of sanding should fix this.
The crank alignment was as perfect it required very little force to get the crank installed in the BB.
The headset is a little tight to get the cabling through. I am using SRAM wireless so only need to worry about two cables but even those took some effort to get around the bends.
Brakes all mounted up fine on the threads. All bottle holder threads are nice and clean.
Not tried the seat mounting yet.
When I tightened the hanger on the back the alignment of the thread is slightly off, ie: a little harder to hand tighten but nothing of a concern.

All in all I am very happy with the frame but until my wheels turn up I wont know how it rides. Attached is a picture of its current state.
December 29, 2024, 05:42:22 PM 		1