See likes

See likes given/taken


Posts you liked

Pages: [1]
Post info No. of Likes
Re: Velobuild VB-R-368 Aeroframe Got it a bit more assambled as I wait for the last parts to arrive in the next few days. BB threaded in easily by hand. Lower headset bearing snug but easy to fit by hand, while top bearing required a bit more force, but still possible by hand.

The custom top cover I got VB to print fits nicely with the spacers for the LC HBR17 handlebar except it didn't have the two small holes that each spacer has. Now I checked I see that the CAD I got from LC and sent to VB doesn't include those (as they didn't send CAD for spacer but rather just the headset top cap), so not any fault of VB. I filed off the two small tabs on the lowest spacer and then all should be good (as it still locks to the top cap by being sunk into it).

Next up is needing to cut the seat post and install the saddle, then put on shifters when those arrive and check the position before cutting the fork steerer.
November 26, 2025, 09:32:08 AM 		1