See likes

See likes given/taken


Posts you liked

Pages: [1]
Post info No. of Likes
Re: LTWOO RX hydro sets Air screw is fine to use.
Here's how used the second (air) screw.

keep the caliper bleed valve closed.
Syringe on the hood bleed screw normally used for the cup.
Open and remove the air screw.
Push fluid from syringe very lightly. 
Fluid will come out of the air hole. So have towel ready.
Put air screw back on. Remove syringe and put bleed screw back on.
Clean any mess.

I have no idea how to use a cup on the bleed hole and open the air screw. 

Remember to unscrew the adjustment grub screw on the level anytime you bleed the brakes. So you fully release the piston to fill the valve. That way you have the best chance of getting the firmest feel. You may still need to tighten up the grub screw.
July 06, 2023, 10:27:18 PM 		1
Re: Recommendations needed on carbon fork cutting tool
Quote from: Froglover825 on July 27, 2023, 12:16:37 AM
I'm doing a new upcoming build and I will inevitably need to cut my fork, any recommendations on cheap tools to get the job done?

I'm looking at this one from ZTTO, has anyone used it, and if so - is it any good?
 https://www.aliexpress.com/item/1005005665891624.html?spm=a2g0o.productlist.main.1.4c707b184Iucwk&algo_pvid=a7b3b6eb-86e3-490d-a49f-6e76d5ad56d6&algo_exp_id=a7b3b6eb-86e3-490d-a49f-6e76d5ad56d6-0&pdp_npi=3%40dis%21AUD%2155.86%2127.37%21%21%21266.15%21%21%40211bea6216904348632738679d077e%2112000033945900665%21sea%21AU%214165551354&curPageLogUid=tdgZiBiGABdX

I just use a cheap hacksaw with fresh blade, an old stem and a few spare washers to cut carbon forks. I then use fine grit sandpaper to even out the cut. Make sure to do it outdoors and wear a mask.
July 27, 2023, 09:47:25 AM 		1