The Tailfin replacement of the original thru axle is complicated imho.
You could just have a rod inside the thru axle.
You could just have a rod inside the thru axle.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: electrolux on November 14, 2024, 03:45:28 AM
No spacers, OEM 105 Chainrings swapped onto the Magene spider powermeter. They run close but enough clearance and no rub. Shifts perfectly.
Quote from: kwantani on November 09, 2024, 11:29:27 PM
I posted the info on the Long Teng thread. here's my info:
-I've a Goodyear Eagle F1 700x32 tire installed, there're about 9mm clearance between the fattest part of the tire and the chain stay.
Quote from: kubackje on November 09, 2024, 04:25:09 PM
And u needed to make w whole separate thread to ask this question... Smh
Quote from: Serge_K on November 09, 2024, 08:10:15 AM
can of primer, 2 cans of colour, can of top coat (one part, the cheap kind). All from local diy store. cost me, idk, 25 eur.
My conclusion: i should have ordered black from the factory and called it a day.
Quote from: Alexander on November 06, 2024, 09:58:37 AM
I've been researching the same for a bit and the list can be quite long but here is a few
- LongTeng LT-301
- Peter's Grevil Clone (XMCarbon)
- Spcycle SP-G056
- Spcycel G068 Aero Carbon Gravel
- Tantan/Seraph GR201 / Tideace FM-GV201 Noah 2024 / LongTeng Gravel Frameset GV201
- YOELEO G21 DB Gravel Bike Frameset