Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Fast4Kom

#1
That looks like it's straight up rubbing on the frame in your two pictures. Have you placed the plastic centering piece on the top bearing? Because I did and there was this nasty gap because it's a few millimetres too thick.
#2
Acros Rosé X-Lite compatible headset insert does the trick. Head set cap needs to be modified to sit flush with the insert. I had to cut 2 pins and grind a a little bit with grind paper.

I had bad luck with the BB overspray tho, too much paint causing pre tension on the BB bearings. Currently sitting in the shop to get faced.