Hi
Does anybody know if this frame is build by a Chinese factory? If Yes who produces it?
Thanks

Does workswell bikes reply to you? I am mailing them from 10 days but not a reply!

Quote from: xcbarny on February 04, 2016, 05:14:33 PM
Yes, that's the same as what I received, when I ordered a PF30 frame.
The adaptor is glued in, and can't be removed (even they said that they couldn't remove it after I sent it back to them).

In my case, I couldn't use the frame, as I needed to fit an Eccentric BB in there, but maybe you can just get a 24mm Crankset?

I was dealing with Yoyo Yang, and found him very hard to deal with. On several occasions, I tried to explain to him why this frame would not work for me, but he never seemed to understand. They also wanted me to pay for them to ship a replacement frame back to me, which I refused, and I eventually got a refund. (but it still cost me $50 to ship it back to them.)

Unfortunately, they don't seem to understand what PF30 is, he kept telling me that they sent me a PF30 frame, even though it would no longer accept a PF30 bottom bracket.

Have you been in contact with them about the issue?

I think if anyone is looking to buy this frame, then they should avoid the PF30 option, and go with BB30 or BSA.

For me this is ok because I have a gxp xx1 crank. But..is it safe? I am worried about the glue!

This is what I have received!!
Is it glued for you? I cannot understan! I have just ordered a pf30 frame.
They told me that the bb will be free with the frame. In fact this is ok for bsa cranks. They also send me an adaptor to reduce the diameter and mount also gxp

I have received the frame with pf30. All of you have received it with the bottom bracket installed? Is it only installed or also glued?

Has anyone bought it in bb92 version?

What is EBB? Sorry for my ignorance. I have to buy a frame for an xx1 gxp crank. What do you suggest me, bsa o bb92?

Thank you so much! Now I can order it!

Quote from: LHSN on September 21, 2015, 12:26:06 AM

Quote from: Petenausen on September 19, 2015, 02:20:54 PM
Is it possible to mount a 156mm sram xx1 crank on the bb92 version of this frame? My worries are about the q factor

Q-factor should not depend on BB type. so if I have 156Q with GXP BSA, then you won't have problem with clearance.

Yes but is 156mm ok for this frame or do have I to mount 168?

Hi to everyone I'm Matteo and I'm from Italy! I'm looking for a new Chinese frame so I'm here!!

Is it possible to mount a 156mm sram xx1 crank on the bb92 version of this frame? My worries are about the q factor