Did anyone replace the bolts and axles on their X68?

as some of my bolt start to rust (especially fork clamp) I was thinking about replacing at least some. Can I use the genuine bolts?

Dear fellows,

a topic is crossing my mind every now and then as I get deeper into the cycling rabbit hole: are there any well established sellers that do custom kits in small quantities? Would love to design and rock a jersey with a couple of friends.However, quantity would most likely be <10.

Best regards,
Freddy

Build is complete and has the first 500km on it. So far really happy with it and how the build (my first) went. No major challenges besides rear caliper facing.

So I just got my frame delivered, took quite a while during the holidays in germany. Do you need some Screw measurements or did you receive yours now?
Quite happy with mine, the paintjob looks really good, just the brake mounts are sprayed over quite a bit.

The adapter for front brake is not good, one counterbore is way too deep so I can't use it. You guys reckon Tantan will send me a replacement or just don't bother and get it somewhere else?

Mine is there as well, thank you!

My plan was to exchange all relevant bolts of the X68 to higher grade (Ti) bolts.

Anyone knows which bolt dimensions are needed for an SL8/X68?

As my frame is currently on route to me: any recommendations regarding a good Wahoo Mount?

Anything else worth upgrading?

Thx

Wheelset ordered