i have made custom spacers for my 3T exploro. i have used petg CF to print it.
No problem after one year. di not touch the setup of the headset.
No problem after one year. di not touch the setup of the headset.
- Welcome to Chinertown.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Road Bike Frames, Wheels & Components / Re: 3d printed stem spacers???
October 21, 2026, 10:56:00 AM #2
Component Deals & Selection / Re: Pass Quest chainring question
October 21, 2026, 10:45:07 AM
not sure the washer is for the chainline. looks like it is only 1mm.
I have a carbon spider for which i need to add a washer to tight it otherwise it enough thick.
I have a carbon spider for which i need to add a washer to tight it otherwise it enough thick.
Pages1