I assembled two TT928 frames from Tantan in September. I had the TT912 before that. Personally, I found the TT912 easier to assemble, especially when it came to the fork. You have to cut the TT928 fork down to a fairly short length. It creaks a lot, and there's not much clamping surface. You have to attach the Sapacerturm to the base before you secure the base to the fork; otherwise, you won't be able to thread the long screws through from below. I think that's a design flaw, too.
The worst part is the cover for basebar-fork clamp area. The mounts don't work at all for me—on both bikes. The design is really bad. There's just a small clamping tab, and that's it. I haven't found a solution yet for how best to handle this. I'm curious if you're having the same issue.
A BTA system would be really cool. And a tool box for the frame triangle.I haven't found one yet and my cad skills are very limited:D.
The worst part is the cover for basebar-fork clamp area. The mounts don't work at all for me—on both bikes. The design is really bad. There's just a small clamping tab, and that's it. I haven't found a solution yet for how best to handle this. I'm curious if you're having the same issue.
A BTA system would be really cool. And a tool box for the frame triangle.I haven't found one yet and my cad skills are very limited:D.
