Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mattias

Pages: [1]
1
Road Bike Frames, Wheels & Components / Re: Looking for best Chinese frame XR4? Velobuild? Trifox Elves?
« on: October 26, 2021, 03:00:35 PM »
Hi, I think you have to look with Yoeleo R12 is pretty close to the frame you re looking for, looks like for your user name you live here in Seattle

2
Road Bike Frames, Wheels & Components / Re: Velobuild VB-R-168 Frame
« on: July 13, 2021, 11:04:43 AM »
Quote from: jokage on July 12, 2021, 09:59:10 PM
Finally. Mine is being shipped just now  ;D

Chris just texted me and he confirmed, the 2nd frame was sent out already, let's see!!

3
Road Bike Frames, Wheels & Components / Re: Velobuild VB-R-168 Frame
« on: July 11, 2021, 12:28:27 PM »
Quote from: vasnd on July 11, 2021, 03:04:55 AM
Is anyone running 140mm on front? Looks like I need to use the 160mm adapter..

Edit: nvm my dumb ass probably overlooked the double orientation of the adapter

Nope they sent me one frame of two I bought from them and now they said the will sent the second one ASAP which I doubt about it!!

4
Road Bike Frames, Wheels & Components / Re: Velobuild VB-R-168 Frame
« on: July 10, 2021, 12:11:19 PM »
Update from Chris:
Yes, We sent one frame, only via mistake, we will send another ASAP

I really do not understand how that company works, how is possible if you have a invoice indicating two frames you only send one by 'mistake'

5
Road Bike Frames, Wheels & Components / Re: Velobuild VB-R-168 Frame
« on: June 17, 2021, 01:38:47 PM »
He reply to me, the delay is because the 420/110 is the reason of the delay :-\
New response from Chris
-Handlebar molded out and we will send to painting shop next week-

6
Road Bike Frames, Wheels & Components / Re: Velobuild VB-R-168 Frame
« on: June 12, 2021, 03:25:06 PM »
Quote from: braincore on June 12, 2021, 12:26:07 AM
I just installed the tubeless tire, added the tire sealant, and was pumping it up when the wheel sidewall ruptured at around 60psi. Has anyone seen this before?

The installation was straightforward otherwise. I did use a tire lever for the last bit, but that was over the presta valve (opposite side of this photo). Is there something I could have done to cause this? I'm using a floor pump (Topeak), not an air compressor, and my pumping wasn't excessive, so I don't think the pressure gauge could have been far off.

Hopefully I can get a replacement though I am a bit concerned about the safety now...
The red tape was not intended for tubeless, you need a tubless rim tape

Pages: [1]