Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - silk_91

#1
Quote from: cme on November 01, 2021, 11:06:25 PM
You can certainly choose not to feed cables through the handlebars - just tape them to the bars. Or I suppose you could feed them into the holes marked 16.2*12 and out the holes marked 16*8.5.

Then feed the cables into the holes in either side or top of the frame. No changes to headset or anything aftermarket required.

I've built two of these - one with a flat handlebar & necessarily external cable routing - and one with Carbonda's handlebar and internal cable routing. No regrets with either.

With 4 ,,cables" or only 2 meaning wireless group?
I am planning with Shimano 105, not sure if I should go for the fully hidden installation.
#2
No idea, thats what she replied.
If you put a 28mm tire, the remaining gaps will be 4.5mm per side, is that enough?
#3
I am also interested, got this reply:
The CFR 515-D maximum tire clearance really only 25mm,
According to the regulations, the left and right sides need to reserve a 6mm gap, otherwise the tire will wear the frame.

FM 1056 Max tire size: 700*32mm
#4
Thanks a lot! What is your saddle height from the BB? Mine would be 76cm and I am not sure if the seat tube is too short for that, meaning whether the saddle post goes into the seat tube deep enough?
#6
Did anybody use their aero handlebar CHB1036 and guide through 4 lines? Is it easy/doable?
#7
Quote from: jstrawks on November 01, 2021, 06:19:49 PM
I love these builds. Mine is about 95%:
What is the color code of this beautiful red?
#8
Does anybody know if I can use their cockpit with external routing instead of internal?
http://www.carbonda.com/accessory/handlebar/109.html
Do I need different headset or anything from aftermarket?
Thanks
#9
Which color is this? It is amazing!
I also want to build up a red CFR 1056, just cannot decide which red tone I should go for, so far I am leaning towards RAL 3001 signal red.
I am planning with Shimano 105. Based on your experice, could I go for the cockpit offerey by Carbonda and do internal routing? Meaning all 4 cables?
thanks!