Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ANITO1971

Pages: [1]
1
Component Deals & Selection / Re: Improved hoods for Sensah brifters
« on: August 28, 2023, 02:50:44 PM »
I also apply a small strip of handlebar band arrond the cable hosses to make a smooth transtion of handlebar band and rubbers ower the hosses.
On Original rubbers this was the area where the original rubbers first wear out and get broken...

You also get 4 additional coulours of hood rubbers, Green, Pink, light red and light blue...

2
Component Deals & Selection / Re: Improved hoods for Sensah brifters
« on: August 28, 2023, 02:10:34 PM »
Fotos for you... Sensah "alternative" rubbers

3
Component Deals & Selection / Re: Improved hoods for Sensah brifters
« on: August 28, 2023, 01:31:18 AM »
Yesterday I installed "alternative" Sensah rubber hood covers.
My old Original Sensah rubbers were worn out after 18.000km... and broken allong cable hoses. I put some some tape allong cable hoses, to meke it smoother

"alternative" rubbers are fitting better than originals, much tighter fit. No sliding at all.
How long will it hold I dont know

Will post foto soon

4
Component Deals & Selection / Re: Groupset News
« on: June 04, 2023, 01:42:56 PM »


China cycling has posted first video Using Sensah Hidraulic road/grawel set

5
Component Deals & Selection / Re: Groupset News
« on: May 08, 2023, 02:01:09 PM »
Quote from: TidyDinosaur on May 07, 2023, 09:26:56 AM
Sensah print already coming off the levers... Had the same thing happen to mine...

I have my Sensah Empire PRO  in 3rd season, I have made total of 15.000 km... Printing on carbon break levers is as good as new..

But I must admit something...Sensah in my case is reberended to "Retospec", the brandname in use by my bike supplier...

Pages: [1]