Ok, I'm big Cannondale guy and today I saw how much my LBS want for low spec Topstone Carbon (10s grx and worst wheels I ever ridden)
3130 Euro w/ Tax!

This is my ,,Cheap GR201,, build (still waiting for most parts and frame):

Frame and UDH hanger 616,00 € 1377g mondince
Fork 0,00 € 438g mondince
Bottom bracket 32,00 € 105g Token T47
Crankset 95 € 570g RiRo Carbon 50/34
Front derailleur 81,00 € 138g Di2 105 2s
Rear derailleur 150 € 301g Di2 105 12s
Wheels 357 € 1610g Elite wheels ENT 38mm
Headset 0 € 103g mondince
Stem and Handlebar 73 € 340g Toseek 5500
Handlebar tape 2 € 10g bucklos
STIs 174 € 442g Di2 105 ST-R7170
Di2 battery 111 € 53g DN300 shimano
Brakes 49 € 2x 95g ZRace XG
Brake discs 11 € 2x140mm 68g aliexpress
Gear cables 26 € 2x10g 2xDi2-300 Shimano 950mm EW-SD300-I
Brake cables 0 € idk ZRace
Cassette 22 € 350g ZRace 11-34T 12s
Axles 0 € 72g mondince
Tires 0 € 920g maxxis 700x33 (had them from a friend)
Saddle 55 € 196g Bucklos fake S-works
Seat post 0€ 165g mondince
Chain 20 € 268g kmc x12
Expander 0 € idk Toseek
Tubes 6 € 74g TPU aliexpress
Brake fluid 0 € 50g Shimano (laying around)


Summary 1880 €  around 7970g

 Probably under 8KG and there is still few things to cut weight 
Viva La 11.11 Aliexpress sales

I ordere and assambled my frame from Spcycle official store on aliexpress at the end of april.
Overall, good quality for the price.
On frame and fork there is a lot of tyres cleareance, I use 40 mm tyres and I think 50 mm will fit without any issues.

Nice that they changed it and send it out to existing customers. Did you paid any taxes or anything importing your frame to Macedonia? I live in Croatia and Hygge claims no duties or taxes for EU countries so...

Cheers!

Have you put carbon paste ? No seatpost slipping ?

I also had a creak that I could not find the source of. Took a while until I figured it out.
You should check te following: on the rear dropout - drive side- the part where the axle screws in, is made up of 2 aluminium parts that are held together with that tiny silver screw. The outside part has a cylinder with thread in which the axle goes. On my bike this cylinder protruded too far on the inside, past the inside surface of the inside aluminium part(so past the inside of the DS dropout). The problem was that the wheel axle was not clamped hard enough between the two dropouts and this caused the wheel to move a very tiny bit every time I put force on the pedals. Just enough to cause an annoying creak every time I pushed the pedals.
The solution was to sand down the cylinder just enough so that it stayed on the inside of the inner part. When you tighten the thru axle, the axle of the wheel is now clamped between the 2 dropouts.
I hope what I'm writing here makes any sense. It's hard to explain...