Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - nstrug

#1
29er / Re: LCFS917
June 06, 2024, 08:57:48 AM
Turned out that the DS lower bearing was not pressed completely home and as a result the spacer was sitting slightly into the frame mount resulting in a gap. Pressed it home and all was fine.

I've since ridden the bike and it's spectacularly good - climbs beautifully and very assured on the downhills.

#2
29er / LCFS917
May 15, 2024, 05:10:37 AM
Hi -

Light Carbon 917 almost finished.

First time building an FS bike, although built loads of hardtails and road/gravel bikes.

My one niggle is I have clearance on the trunnion mount that I'm not happy with. It's 0.2mm on the NDS side which I can live with but a whopping 1.1mm on the DS which I think will put undue stress on the shock mounts when torqued up.

Is this to be expected and what do people generally do in this case? I have a 3D printer so could print a spacer easily enough and as its only in compression it should be solid enough.