Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Cirion

Pages: [1]
1
Cyclocross Frames, Wheels & Components / Re: Carbonda 505SL Integrated Stem
« on: September 09, 2024, 05:14:36 AM »
Hi, thanks for the precisions.

I'm planning to use Sram AXS components (only two brake lines and no cables).

As the steerer tube has a hole, then I think I'm not limited to the ACR system (where the stem seems to be designed to allow the front brake line to pass through the inside of the steerer tube from the top). This opens up my possibilities, and I guess I should be able to use, for example, the Deda DCR system or a Ritchey comp switch stem with the fitting headset.

My idea was to be able to test different stem sizes at first before settling on an aero handlebar/stem of the right size.

About brake rotors, do I need a 140mm to 160mm adapter for the front or the rear (front according to carbonda)?

Thanks a lot!

2
Cyclocross Frames, Wheels & Components / Re: Carbonda 505SL Integrated Stem
« on: September 06, 2024, 03:38:50 AM »
Hi everyone, first post here, nice builds!

I have a 505sl on the way. I have a few questions to which Carbonda's answers were not realy clear.

I chose the version with internal routing. Carbonda's description is as follows: “If you choose internal routing, the frame needs to use internal routing fork and it will have cable routing holes at the headtube”.
I'm not sure to understand. Is there a hole in the steerer tube? Is it possible to use other systems than FSA ACR, or does it have to be ACR compatible? Not being limited by ACR compatible components would open up the stem options for my build.

According to carbonda the rotor size would be 140mm (160mm with adapter) at the FRONT and 160mm at the REAR, is this correct?

Thanks for your answers

Pages: [1]