Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gbgigli

Pages: [1]
1
29er / Re: IP-036 29er Full Suspension Carbon Frame Build
« on: January 21, 2015, 07:28:04 PM »
Quote from: turboenterprise on January 21, 2015, 07:24:09 PM
yes mine were 8mm. Those dtswiss bearings are a bit different than the RWC so I am not sure. Right 2x22.2 and one shim possibly.

Thanks again!
From what i was reading those on RWC are kind of a new deal for Shox. They are replacing the DU Bushings with Needle Bearing wich according to then is wayyy better! The link i post was from DU Bushings style.

Im really thinking in ordering one of those IP-036... i was about to buy a Niner Jet 9... but even on sale the price is more then double!

2
29er / Re: IP-036 29er Full Suspension Carbon Frame Build
« on: January 21, 2015, 07:07:20 PM »
Quote from: turboenterprise on January 21, 2015, 06:27:58 PM
Yes 165x38 or 6.5x1.5.   I measured my 036 at 22.2 and 22.7mm so i purchased two RWC http://www.enduroforkseals.com/id275.html one shim.  I used a digital caliper to measure the gaps but others have reported 22.2 on both sides.

Thanks for the reply!
So i would need the shock + 2 X 22.2 rwc mounting spans (62 bucks) ?

Im planning on using a DT Swiss Shock. Could i use 2 of these sets:

http://www.bike24.com/1.php?content=8;navigation=1;product=6310;page=1;menu=1000,2,119;mid=0;pgc=0;orderby=2

In the 22.2 measure. If yes... would it be 8mm ? Thanks

3
29er / Re: IP-036 29er Full Suspension Carbon Frame Build
« on: January 21, 2015, 05:45:11 PM »
Hello Friends.
Im looking to buy a IP-036 from Peter.

Could someone give me more specifcs on shock configuration?
Its a 165x38mm shock, correct?

And what about bushings, wich ones do i need and measures? I was looking at some shocks and every store says "No bushings included, you will need to buy a pair". And then there is a lot of measures.

Thanks for the help!

Pages: [1]