Hey everyone, I'm having an issue with the rear end of my ICAN Graro frame and wanted to see if anyone else has experienced something similar.

The rear wheel feels loose even when the axle is fully tightened — there's still noticeable movement. It feels like the axle that came with the frame may be too long, because it bottoms out before properly clamping the wheel.

On top of that, my UDH hanger has failed. The steel sleeve inside the hanger actually split apart, which makes me think the axle may not be clamping against it correctly.

Could other Graro owners check their rear axle length and confirm whether theirs clamps down solidly with no wheel movement?

Quote from: PScott on November 26, 2025, 09:29:03 PM
What groupset are you guys pairing with the LCR018-D? I'm new to building up a bike from scratch and past bikes are have all been mechanical.

Considering L-Twoo ER9 Version 3.
Yes/No/Maybe so?

Don't go L twoo

Just received the set. So far update firmware and planning to install on the bike this weekend.
Anyone know what tool to use to unscrew the end caps on the crank?

Quote from: BeR on October 20, 2025, 07:24:44 AM
I confirm. It was so easy to align calipers (less than 2 minutes).

Good to hear
Thanks

Hi All
I was told by Wendy that the brake caliber surfaces are faced.
Can anyone with the frame confirm this and post some pictures?

I had the same experience as you.
I'm confused why they included all head set components but the c ring.
I had to ordered a whole headset kit from AliExpress since Perry didn't want to send me one

Hi
Here is my finished bike build.

I went with Kocelvo stem and headset combo

Anyone know what's the bb width and spacer will fit the frame?

How long did it from placing the order to receiving the frame?

What are your concerns?
Chain line?
Sprocket clearances?
What brand of BB are you using?