Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - xeitto

Pages: [1]
1
29er / Re: Dropper Post Cable Routing on IP057
« on: March 25, 2015, 10:53:19 AM »
ok guys, thank you! i'll buy a kind shock lev...  ;)

2
29er / Re: Dropper Post Cable Routing on IP057
« on: March 25, 2015, 02:31:08 AM »
Are you sure there is a sleeve or are you just guessing? If you route the cables with the housing through the frame there shouldn't be an additional sleeve.

See this quote:
"The plastic tube(s) that come in the frame are a tool, not a part of the bike. Feed the bare cable through the tube, pull the tube over the cable to remove it, then back-feed the housing over the cable to push through the frame. Full-length housings work here. To change cables, pull out the housing, push the tube over the cable, and pull out the cable to return to step one."

3
29er / Dropper Post Cable Routing on IP057
« on: March 24, 2015, 11:33:33 AM »
Hi everybody,

I just ordered a IP057 frame and I have a question. I'll run a 1x10 Setup so the routing in the top tube is free.

I'd like to use a Reverb Stealth Dropper Post, because I have one here already and it would be the cleanest possible look. Can somebody tell me if it's possible to route the cable from the top tube into the downtube? See picture attached. It looks like there is enough space but I'm not quite sure...

Thank you!


Pages: [1]