Foam tubing

[svanimpe]

Does anyone have any recommendations on where I can buy foam tubes, to put around hydraulic hoses to stop them rattling in the frame?
I suspect most Chinese frames don't include any foam/sleeve for this.

[wfl3]

I got a few bags of these for the next time I re-cable any of my bikes:
https://www.wiggle.com/lifeline-internal-routing-anti-vibration-foam


In the meantime I cut a segment out of a pool noodle I found in the garage - about the length of the downtube from the cable exits to the headtube - and pulled the fork out so I could shove it down under the cables through the headtube.  I'd say that it's been about 99% effective.

[carbonazza]

Here is another option that comes in 2m long
https://r2-bike.com/CAPGO-OL-Noise-Protection-for-Brakehose-Braking-Outer-Shell-2m

[svanimpe]

Thanks

[RobertRinAustin]

Any good Ali options?  Shipping to the US makes the European offers not cost effective.

I ordered some back in the fall and it was just heavy rubber tubing.

[bxcc]

Not sure about Ali options but McMaster Carr is great. Looks like a 10 foot section is only $7.54 with an inner diameter of 1/4". That should do for getting rid of the rattles if you can get it to fit inside the frame.

https://www.mcmaster.com/foam/multipurpose-blended-neoprene-foam-tubes/

[emu26]

Any good Ali options?  Shipping to the US makes the European offers not cost effective.

I ordered some back in the fall and it was just heavy rubber tubing.

Go to your local plumbers supply or hardware co-op and buy some closed cell pipe insulation. Comes in lots of sizes and can be cut easily and squashed to insert via head tube or BB. Heavy by the length but you only need a few short pieces.

[RobertRinAustin]

Thanks for the tips.

[carbonazza]

Go to your local plumbers supply or hardware co-op and buy some closed cell pipe insulation. Comes in lots of sizes and can be cut easily and squashed to insert via head tube or BB. Heavy by the length but you only need a few short pieces.

I was using that too.
It is possible to silence the rear brake and shifter hoses in the chainstay this way, but the dedicated foam tubes are easier.

I tried cheap foam tubes for car doors from Ali, they are ok, but much heavier.
I don't think similar light foam is available( yet  ) from Ali.