Update: I have the frame and some cool and bad things.
Coolest surprise was 32mm gp5000 trs fit. Finish was evenly sprayed. Seat clamp came with a 10mm bolt. Using the bolt helps installing for anyone who rides without a cutout saddle. Internals look pretty good. Very little globs of resin. I didn't see loose bladder or fiber. The internal seemed layered well looking around headtube and bb areas.
There was care in running cable guides and packaging. There was extra Packing wrapped around all ends of the frame. Tons of tape.
Bad: Didn't recieve thru axles or headset bearings. The rear caliper mount was drilled messy not an even oval. The fork looks like it's used for multiple frame types. Fork is marked where to drill for internal routing.
Fork and head tube don't set well together with lower bearing. The Fork and head tube have 45* moulding but the bearing sets inward too far causing binding. Adding a crown race leaves too large a gap and fork sets crooked. It fits flush and rotates smoothly with the bearing setting on 90* with no crown race.I don't like how this leaves the bear resting on 45* cuts with 90* races.
I have extra thru axles to figure out what fits.
Front is L121 m12 p1.5
Rear will work with length L164 to L168 m12 p1.5
Weights for 49cm matte black
Frame : 845g
Fork : 355g
Seatpost : 190g
I already ordered alpinist type bars that are 10mm longer than I usually go for which Im glad after seeing frame. I had plan to build this only as a climber expecting 28mm max. Now I need some time to think if I want to do more with it.
