LCFS911 full suspension

[emu26]

Hi guy's I'm having trouble with bleeding the brakes, I've been trying in several different ways but I cant get the rear brake to it's full potential.

My guess is that it is air in the hoose under the crank, I've been whipping the handle, twisting the handle, tried to bleed the brakes according to shimanos guide, I've been trying to do it the traditional way as you do it on cars but I'm a not satisfied.

Is there anyone else that's been having the same kind of issues?

Lift your front wheel high enough that the crank, and the section of hose that goes under it, are higher than the rear caliper.  Leave it like this for a couple of days and the air will rise to the lever end.  If you are having trouble lifting the front wheel high enough then undo the rear caliber from the frame and let it hang lower to help with the height difference.  Otherwise just follow the shimano guide.

I will note that I have had an XT on the rear of my sons bike that presented problems for ages before it finally failed. It would slowly loose "bite" and the lever would very slowly get more and more spongey. Looked everywhere for signs of oil leaking out and could never find any. Then one day the seal on the piston failed. It was replaced and failed again some time later. So I replaced the whole lever assembly and the brake has been fine since. I suspect that there was a small manufacturing fault in the cylinder that allowed a very slow leak.

[hellomrko]

How are folks liking this bike?
It seems to have the nice things that newer release have utterly failed on: threaded bottom bracket, internal cable routing through the side ports (not headset).
Plus they're open to custom paint job, so that's great.
I just took it to MS Paint and AI to create a quick-and-dirty concept art, to see if they can do this.
I think this came looking really promising, reminiscent of Orbea's paint style.
There was some Fox 32 Factory SC (100mm travel) that I managed to snag during the sales, but haven't found a frameset to put it on, so this paint scheme might work really well.

[hellomrko]

Okay I give up, they must have stopped manufacturing this model or something. I was just informed by their contact that their minimum order quantity is 100.