LTWOO ER9 & ERX - Electronic groepsets

Started by DutchCheapskate, June 05, 2023, 05:37:37 AM

Previous topic - Next topic

mozart

did you check it with another smartphone?

hebron

Yes, tried with my new one im am going to change to soon. But the same phenomenon.
Can not see it my list, but searching for new ones i can find it but not add it.

TCR Boy

I've been dealing with an air ingress into my right shifter brake lever for a while now. I bleed it and it's fine for a few rides then it goes spongy again.

Seller (L-twoo factory store on Ali express) sent new air screws for the shifter which hasn't rectified.

There are extremely slow in dealing with anything.


hebron

Quote from: hebron on October 02, 2026, 02:23:44 PM
Tried search the forum for my issue but did not find a solution.

Used my Erx V3 since may with absolutely no issues at all.
Then i got sick and my bike sat for about 4-5 weeks and now the groupset is gone in the ltwoo app.
The app find the RD but its not possible to do anything, so i cant add it again.

Tried emailing Ltwoo but no answer as usual when writlng to them.

Does anyone know about a solution?.

After 5 days i managed to fix my groupset. Still dont know what the problem was. For some reason i could connect to it when i was on my company wifi. So i updated the RD and now it works back home aswell. But it was impossible to do it back home or via 5G on the phone.

So for know its back up and running

jonathanf2

My LTwoo ERX v3 rear derailleur crapped out. Not sure what happened. I was tuning the derailleur at home and all of a sudden it just wouldn't shift. I tried resetting and restored the factory settings, but it's both dead with the shifter and the app. I'm talking to 80 Design store right now sending video and screenshots. Overall though it's been working fine with no issues.

I'm waiting on 80 Design store to go through my photos/video and send me a replacement RD under warranty. Strangely, my v1 eR9 RDs have been working rock solid!  ::)

Livingmannequin

I got a strange problem that might be related to the battery:

After not using the bike for 2 month as i was traveling and became sick after it now won't work without being charged.
When I look at it in the app (while it's getting charged) it says it's full but when I disconnect the cable it instantly shuts off.
Already dis- and reconnected the cables but that didn't do anything. Will check the battery tomorrow but I can't imagine what could be the case...

jonathanf2

Which version are you running? Also doe it at least shift in the app? I'd try standard 800mah batteries and see if those hold charge. I had a similar issue awhile back and it was battery related.

Livingmannequin

Quote from: jonathanf2 on October 14, 2026, 05:13:15 PM
Which version are you running? Also doe it at least shift in the app? I'd try standard 800mah batteries and see if those hold charge. I had a similar issue awhile back and it was battery related.

Version 1.5 and yes i can shift from the app but only when charging, once i disconnect the cable it's dead. Due to a battery holder disintegrating I got a replacement one which is a sealed one so I can't change the cells... Will see what I can do

MeoMeo

I have purchased an Ltwoo EGR 1x 13-speed derailleur; can I install a 10-46t SRAM Rival XPLR cassette and a SRAM Flattop chain without any issues?

Ludo

yes it should work as far as I understand it.

jonathanf2

Quote from: MeoMeo on October 16, 2026, 11:05:10 AM
I have purchased an Ltwoo EGR 1x 13-speed derailleur; can I install a 10-46t SRAM Rival XPLR cassette and a SRAM Flattop chain without any issues?

Yes. Just adjust the tension screw to accommodate the slightly smaller 10t cog.

delarune

Quote from: MeoMeo on October 16, 2026, 11:05:10 AM
I have purchased an Ltwoo EGR 1x 13-speed derailleur; can I install a 10-46t SRAM Rival XPLR cassette and a SRAM Flattop chain without any issues?

I don't think so. The 13s xplr cassette will probably be too wide. They way sram solved it is to removed the udh and use an xplr derailleur which is thinner and makes room for a wider cassette (se my earlier post). Please report back if you manage to do it.

jonathanf2

Quote from: delarune on October 17, 2026, 08:37:39 AM
I don't think so. The 13s xplr cassette will probably be too wide. They way sram solved it is to removed the udh and use an xplr derailleur which is thinner and makes room for a wider cassette (se my earlier post). Please report back if you manage to do it.

Most the issues I hear are from 14 speed that need the thinner UDH hanger in order to clear the Sentyeh RD. Though we won't know unless someone tries with a 13 speed cassette.

delarune

Quote from: jonathanf2 on October 17, 2026, 09:32:19 AM
Most the issues I hear are from 14 speed that need the thinner UDH hanger in order to clear the Sentyeh RD. Though we won't know unless someone tries with a 13 speed cassette.

I have tried it. Had to use a 2mm washer between frame and cassette to make it fit. It works but would not call it a fit without issues.

jonathanf2

Good news. After showing video evidence of my RD not working, 80 Design Store is sending me an eRX replacement. Props to them, but I'm a bit concerned spare parts are somewhat scarce now for LTwoo products. On the other hand, Wheeltop parts are easily accessible either from Wheeltop direct or various third party sellers on AliEx. With the new Wheeltop fine-tune ability, I feel they might be the better investment for long term reliability.