SRAM brake hose replacement

[Kamool]

Unfortunately, I cannot shorten my rear Force AXS brake hose anymore, so I have to replace that. I don't want to buy a whole SRAM set with olives and barbs, because I have a lot of spares. I'm looking for just a brake hose. Anything you can recommend? I've seen EZmtb K28 brake hose and A2Z PVDF-5.0, but are those worth it?

[alfiomotrambo]

You can get this cheap one https://it.aliexpress.com/item/1005010725414427.html will work

[Kamool]

Which one is for SRAM? Is that 5.0mm OD and 2.2mm ID (Magura)? I've found information that it should be 2.1mm ID, and there is no such hose.

[s3si1u]

I've used this in the past:
https://www.aliexpress.us/item/3256808307750750.html?
It works fine, no complaints.

[Uberflo]

I had these. Not very suitable for integrated bars as the hose is very stiff. Normally I use Trickstuff Beta Kevlar hoses.

[Kamool]

I had these. Not very suitable for integrated bars as the hose is very stiff. Normally I use Trickstuff Beta Kevlar hoses.

That do you mean by "these"? EZmtb or A2Z?

[Uberflo]

The one posted by s3si1u

[s3si1u]

I had these. Not very suitable for integrated bars as the hose is very stiff. Normally I use Trickstuff Beta Kevlar hoses.

This is true, it's stiffer than the original hose. In my experience it's still possible to route in a fully internal setup but may not be the easiest solution for those who don't do this often.

[Uberflo]

This is true, it's stiffer than the original hose. In my experience it's still possible to route in a fully internal setup but may not be the easiest solution for those who don't do this often.

I do this often but there is chance that you bend the line because of its stiffness