Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mongod

Pages: [1]
1
So the saga continues. My frame was initially shipped in April, arrived in my country in May but due to a fuck up by the norwegian postal service it was shipped to the other side of the country, and when they finally realised what they had done they managed to return it to Seraph instead of sending it to me. Super annoying and it resulted in me having to pay twice for shipping as they (postal service) said only the sender could request a refund. Shit, ok I'll pay again as Jessi said this would be a big hassle and I just wanted the frame asap.

Cue to today, I finally got the notification that the package had arrived and was ready for pick up. Drive straight to the post office and my heart sank when I saw the package. A huge hit on a corner. I hoped for the best but when I inspected the frame there is severe damage in the head set, and the frame is likely just garbage now. Sent Jessi an e-mail right away and am hoping for a quick reply as it's been four months since ordering and I really don't want to wait until the season is over before getting a new one.

What do you think? Bearings won't even go in and regardless I wouldn't dare to ride it with this crack. I feel it inside the head set too, so it's probably worse than it looks too..

That's unfortunate! That frame is toast. You could probably get it repaired but not worth the hassle. I would ask them to send out a new one.

2
Got pictures of the clearance with TB 2.1 on fd?

About two keys worth.

3
What did you swap the rear to? With a FD max maybe 48 or 50mm?

Thunder Burt 2.1.

4
Do you have the P505 or P515 PM? Did you need/use any spacers or did it fit "as is"?

What tire options are you looking at for that rear wheel?

P505. Used a 1mm spacer. To check for rub I marked the frame with a felt pen, tightened up the cranks and gave a few turns under load. Then I made sure none of the marker was rubbed off by the crank.

Ended up going with THUNDER BURT 2.1. Gave me a bit more clearance. This is with 25mm internal width rims.

5
Built it up last night.
-105 DI2
-Magene PES PM
-2.2 Racekings. Will have to replace the rear, clearance is too tight
-52cm frame

6
I ordered from Tan Tan, did you guys get thru axles with your order?  Just got my frame and bars and none were included.

Thanks.

7
I just ordered a frame a week ago. So not left factory yet. Did they not send you a photo of frame after painting and before dispatch? I've been emailing Jessi and she (I'm actually not sure of gender, I'm presuming she) said she would send photos after spray job, I'm hoping I can confirm mounting points at that stage before dispatch.

Hey there - did you ever get you frame shipped yet? I payed on March 24th - custom color + some wheels, and I haven't got any photos or a tracking number. Ordered from Jessie via email.

Pages: [1]