Someone told me i should buy a cheap screw in pressfit bb but swap the bearings. How would i do this? I know wheels mfg has one for like $200 but can someone throw me an aliexpress link if theyve done it? Thanks

Also, taking recommendations for bearings to replace it with.

You'll want a tool something like this or this. I can't vouch for either as I haven't used them although I'm planning to buy one to do the same thing.

I just used a 1/2" extension and a hammer to get the old bearings out, and a big enough socket to get the new bearings in.

When nothing else is available, a flat screw driver or a 8mm Hex key and a hammer can do the job too.
Just hit gently over the whole circumference of the bearing.

If the bearings is too far, it may disassemble(with a press too), leaving the outer race only in the frame.
Although more challenging a hammer with a flat screw driver can get it out.

some WD40 also is very helpfull

Thanks fellas. Bb86 is the same size as bb386 right?

Nope, BB86 is 41mm frame diameter for 24mm crank axles, BB386 is 46mm frame diameter for 30mm crank axles.

Okay. Those tools dodnt say bb386 unless im blind. I run bb386 dub.

Edit: nevermind. Descrip says im good. Im assuming even though its dub a bb386 tool is fine right?