Chinese Carbon MTB > 29+ & 27+
CS-496 Build / 27.5+
Carbon_Dude:
Looking forward to seeing this build progress forward.
MTB2223:
--- Quote from: Carbon_Dude on September 13, 2016, 06:41:53 AM ---Looking forward to seeing this build progress forward.
--- End quote ---
+1 and with a lot of pictures ;D
SportingGoods:
Rear wheel is laced! Time to get to the truing stand ;D I put the fork and bar to stabilize my "stand" :)
And here comes the first problem. When I put on the axle, it is too long. I can't tighten the hub, there is 2 mm once screwed to the max. That's the axle I bought from Peter, together with the gift frame. Either the axle is too long, or there is a missing metal piece on the frame. :o
Disc side
Drive side
Carbon_Dude:
Almost looks like there should be a metal dropout on that side. Even though I know this has been discussed before.
cmh:
--- Quote from: Carbon_Dude on September 13, 2016, 01:59:20 PM ---Almost looks like there should be a metal dropout on that side. Even though I know this has been discussed before.
--- End quote ---
Get some washers to fill the gap? Seems a bit ghetto but not completely out of the range of feasible.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version